The best shingles for Tri-Cities heat and wind are architectural asphalt shingles with a Class F or Class H wind rating, installed with the manufacturer’s matching starter strip, underlayment and ridge cap so the wind warranty actually applies. For the heat, a lighter or “cool” granule color helps some, but attic ventilation does more. Here’s how we think about it when we’re standing on a roof in Kennewick in July.
Why are Tri-Cities roofs so hard on shingles?
Tri-Cities roofs are hard on shingles because we get desert heat and steady wind with almost no rain to soften either one. Kennewick’s average July high is about 90 degrees based on the 1991 to 2020 climate normals, and most summers we string together days over 100. Energy.gov notes a standard dark roof can reach 150 degrees or more on a sunny summer afternoon. That heat bakes the asphalt, dries out the seal strips and makes granules let go sooner.
Then there’s the wind. We don’t get hurricanes, but we get gusts that run down the Columbia and across open ground with nothing to slow them. Chinook events often push past 30 mph. Wind looks for any shingle whose seal strip has already given up, and once one lifts, the next one goes. Add our low rainfall (under 8 inches a year) and winter freeze and thaw cycles, and you have a climate that finds the weak spot in a cheap roof fast.
What wind rating should shingles have in the Tri-Cities?
Shingles in the Tri-Cities should carry at least an ASTM D3161 Class F rating (tested to 110 mph) and ideally ASTM D7158 Class H, which is the highest wind class for shingles with a factory seal strip. Most architectural shingles from GAF, CertainTeed and Owens Corning meet both.
The rating is a lab test of the shingle. The wind warranty is a promise from the manufacturer, and it almost always depends on how the roof was installed, not just what shingle was used. A Class H shingle nailed too high or installed without the matching starter strip can still blow off, and the warranty may not cover it.
Are architectural shingles better than 3-tab in wind?
Yes, architectural shingles hold up better than 3-tab in wind. They’re laminated from two layers, so they’re heavier and stiffer, and there’s no cutout tab for a gust to grab. Standard 3-tab shingles are a single layer with slots cut into them, and those tabs are exactly what you see flapping on older roofs around West Richland after a windy night. Nearly every new roof going on in the Tri-Cities now is architectural, and the price gap between the two has gotten small.
Which shingles do we install for heat and wind?
We install GAF Timberline HDZ on most Tri-Cities roofs. CertainTeed Landmark is the other architectural shingle homeowners here ask us about most, and both do well in our climate. Here’s how their wind coverage compares.
| Shingle | Wind coverage | What it takes to qualify |
|---|---|---|
| GAF Timberline HDZ | WindProven limited wind warranty with no maximum wind speed | LayerLock shingles plus four GAF accessories: starter strips, roof deck protection, ridge cap shingles, and either leak barrier or attic ventilation |
| CertainTeed Landmark | 110 mph standard, 130 mph as an upgrade | Upgrade requires CertainTeed starter and CertainTeed hip and ridge |
We’re a GAF Certified Contractor, so the WindProven coverage is available on our Timberline installs when the full accessory system is used. The accessories aren’t upsells, they’re the parts that keep the edges and ridge from being the first thing to go.
Does shingle color matter in Tri-Cities heat?
Shingle color matters some, but less than people expect. According to Energy.gov, a reflective roof can stay more than 50 degrees cooler than a dark roof in the same sun, and manufacturers now make “cool” granules in darker colors, not just white and tan. CertainTeed’s Landmark in Silver Birch is one example that carries an ENERGY STAR rating. A cooler surface is easier on the shingle and on the attic.
Two cautions. First, our winters are cold, and Energy.gov points out that a reflective roof can give up some winter heat gain. For most homes here that trade is still fine, but it’s worth knowing. Second, never coat existing shingles with a reflective paint. Energy.gov warns it can trap moisture and void the warranty. If you want a cooler roof, pick the color when you replace it, and spend the real money on ventilation and insulation. A well vented attic does more for your upstairs bedrooms in August than any shingle color.
What matters more than the shingle brand?
Installation matters more than brand. Any of the best shingles for hot climate and wind will fail early if the crew cuts corners. Here’s what we check on every job:
- Starter strip along every eave and rake, from the same manufacturer as the shingle. It’s one of the most common things missing on roofs that have lost shingles.
- Nails in the manufacturer’s nail zone, the right count per shingle, driven flush. High or crooked nails miss the layer below and the shingle never locks down.
- Matching ridge cap shingles, not cut up field shingles.
- Ice and water barrier at eaves and valleys, and synthetic underlayment over the rest of the deck.
- Balanced intake and exhaust ventilation so the attic doesn’t cook the shingles from underneath.
How much do wind-rated shingles cost in the Tri-Cities?
Architectural shingles with Class F or Class H ratings are the standard product on most roof replacements now, so you’re usually not paying extra for the wind rating itself. Impact-resistant or reflective color lines cost more than base colors. The total depends on your roof size, pitch, how many layers come off in the tear-off, and the material you choose, so a flat number for every house would be a guess. Our Roof Replacement Cost in Tri-Cities, WA page has a calculator that gets you a real range for your home in a couple of minutes. We offer financing and a military discount as well.
Ready to find out what your roof needs?
If you’re in Richland, Pasco or anywhere in the Tri-Cities and wondering whether your current shingles are up to another summer, book a free roof inspection. We’ll check the seal strips, edges and ventilation and tell you plainly what we see. Learn more about Roof Replacement in Richland, WA or Roof Replacement in Kennewick, WA, or call us at (509) 475-0515. Our office is at 3121 Leslie Rd Ste 123 in Richland. Our work comes with a workmanship guarantee.

